5/15/2023 0 Comments Wireshark sniff network traffic![]() ‘Play’ button at the lower right side in the Main tab to initiate the programming. Make sure that Erase, Program and Verify are checked. Images for 15.4 Stack are located with the SimpleLink CC13x0 SDK installation in the folderĬ:\ti\simplelink_cc13x0_sdk_1_40_00_xx\tools\ti154stack\TiWsPc2\sniffer_fw\bin\15.4g Such a tool is often referred to as a network analyzer, network protocol analyzer or sniffer. Your TI 15.4-Stack configuration (See Table 18.). Wireshark is an open source tool for profiling network traffic and analyzing packets. In the Main tab browse to the correct sniffer firmware image depending on Select the CC1350/CC1310 device in the list of connected devices at left side. Perform the following steps to program the Launchpad board with sniffer firmware:Ĭonnect the Launchpad board to the PC with a USB cable. You have wireshark on a laptop connected to the hub - it will see all traffic on the hub. The firmware can be programmed with SmartRF Flash Programmer 2. You dont need wireshark on the app server for that. Firmware Hex Files for 15.4 Stack ¶ Frequency Band The firmware image to use depends on the frequency band and TI-Stack PHY mode. The Launchpad board must be programmed with the correct firmware before it can be used as packet sniffer.
0 Comments
Leave a Reply. |